:::

詳目顯示

回上一頁
題名:臺灣傳統建築彩繪桐油展色劑之研製
書刊名:建築學報
作者:陳靜修盧崑宗
作者(外文):Chen, Ching-hsiuLu, Kun-tsung
出版日期:2012
卷期:82
頁次:頁109-125
主題關鍵詞:彩繪熱體化傳統建築桐油展色劑Colored paintingsHeat-bodyTraditional architectureTung oilVehicle
原始連結:連回原系統網址new window
相關次數:
  • 被引用次數被引用次數:期刊(0) 博士論文(0) 專書(0) 專書論文(0)
  • 排除自我引用排除自我引用:0
  • 共同引用共同引用:0
  • 點閱點閱:32
本研究主要目的係控制熱體化溫度與時間,製作傳統建築彩繪塗料用桐油展色劑,並分析不同條件下製備之展色劑基本性質,以獲得最佳桐油展色劑之熱體化溫度與持溫時間。熱體化溫度包括100、150、200及210℃,持溫時間分別為2.0、2.5、3.0及3.5hr。基本性質分為展色劑機基本性質與塗膜性質,展色劑基本性質包括碘價、酸價、比重、黏度、顏色及乾燥時間,而塗膜性質包括硬度、拉伸強度、破壞伸長率、耐溶劑性、耐光性及耐熱性等,並應用傅立葉紅外線光譜儀(FT-IR)分析桐油熱體化後之化學結構變化。試驗結果顯示,以加熱溫度200℃並持溫3.0hr所製作之桐油展色劑,其作業性與塗膜性質最為平衡且優良。
The main purpose of this study is to obtain the best heat-bodied conditions including temperature and time of Tung oil vehicle for preparing optimum enamel coatings for traditional architecture. The heat-bodied temperatures were 100, 150, 200, and 21℃, and the times were 2.0, 2.5, 3.0, and 3.5 hr, respectively. The fundamental properties of Tung oil vehicle such as iodine value, acid value, specific gravity, viscosity, color, and drying time, and film properties including hardness, tensile strength, elongation at break, solvent resistance, lightfastness, and heat-resistance were examined. In addition, the chemical structure changes of Tung oil vehicle were conducted by Fourier transform infrared spectroscopy (FT-IR) analysis. The results showed that the Tung oil vehicle manufactured at 200℃ for3.0 hr had excellent performances and the best balance between workability and film properties.
圖書
1.李奕興(1995)。臺灣傳統彩繪。臺北。  延伸查詢new window
其他
1.洪純仁譯(1995)。解說塗料學。  延伸查詢new window
2.黃金城,林翰謙,黃俊傑,林栢成,徐婷郁(2002)。桐油熟煉溫度與石灰漿比對地仗耐久性之影響。  延伸查詢new window
3.程萬里(1992)。中國傳統建築形制與裝飾。  延伸查詢new window
4.盧崑宗(2002)。塗料用天然油脂。  延伸查詢new window
5.佐藤弘三(1996)。塗膜の力学的性質。  延伸查詢new window
6.崛口博(1972)。赤外吸收光図說總覽--有機構造化學の基礎と實際。  延伸查詢new window
7.Bentley, J.(1997)。The use of oils and fatty acids in paints and surface coating。  new window
8.Chen, J.; Soucek, M. D.; Simonsick, W. J.; Celikay, R. W.(2002)。Synthesis and photopolymerization of norbonyl expoxidized linseed oil。  new window
9.Cocks, L. V.; Van Rede, C.(1966)。Laboratory Handbook for Oil and Fat Analysis。  new window
10.Derksen, J. T. P.; Cuperus, F. P.; Kolster, P.(1996)。Renewable resources in coating technology。  new window
11.Hutchinson, G. H.(1973)。Some aspects of drying oils technology。  new window
12.Mallegol, J.; Gardette,J. L.; Lemaire, J.(1999)。Long-term behavior of oil-based varnishes and paints I。  new window
13.Mallegol, J.; Lemaire, J.; Gardette, J. L.(2000)。Drier influence on curing linseed oil。  new window
14.Powers, P. O.(1950)。Mechanism of the heat bodying of linseed oil。  new window
15.Van den Berg, J. D. J.; Vermist, N. D.; Carlyle, L.; Holcapek, M.; Boon, J. J.(2004)。Effects of traditional processing methods of linseed oil on the composition of its triacylgiycerols。  new window
16.Wang, C.; Erhan, S.(1999)。Studies of thermal polymerization of vegetable oils with a differential scanning calorimeter。  new window
17.Bentley, J.(1997)。The use of oils and fatty acids in paints and surface coating。  new window
18.Chen, J.; Soucek, M. D.; Simonsick, W. J.; Celikay, R. W.(2002)。Synthesis and photopolymerization of norbonyl expoxidized linseed oil。  new window
19.Cheng, W. L.(1992)。Shape and Decoration of Traditional Architecture in China。  new window
20.Cocks, L. V.; Van Rede, C.(1966)。Laboratory Handbook for Oil and Fat Analysis。  new window
21.Derksen, J. T. P.; Cuperus, F. P.; Kolster, P.(1996)。Renewable resources in coating technology。  new window
22.Hoku, H.(1972)。Review of the Infrared Spectra-Fundamental and Practical of Organic Chemical Structure。  new window
23.Hong, C. R. (Trans.)(1995)。Introduction of Coatings。  new window
24.Huang, J. C.; Lin, H. C.; Huang, C. C.; Lin, P. O.; Hsu, T. Y.(2002)。Influence of tung oil ripening temperature and lime gel ratio on the durability of Di-zhang。  new window
25.Hutchinson, G. H.(1973)。Some aspects of drying oils technology。  new window
26.Li, Y. X.(1995)。Paintings of Traditional Architecture in Taiwan。  new window
27.Lu, K. T.(2002)。Natural oil for coatings。  new window
28.Mallegol, J.; Gardette, J. L.; Lemaire, J.(1999)。Long-term behavior of oil-based varnishes and paints I。  new window
29.Mallegol, J.; Lemaire, J.; Gardette, J. L.(2000)。Drier influence on curing linseed oil。  new window
30.Powers, P. O.(1950)。Mechanism of the heat bodying of linseed oil。  new window
31.Sato, C.(1996)。Mechanical properties of films。  new window
32.Van den Berg, J. D. J.; Vermist, N. D.; Carlyle, L.; Holcapek, M.; Boon, J. J.(2004)。Effects of traditional processing methods of linseed oil on the composition of its triacylgiycerols。  new window
33.Wang, C.; Erhan, S.(1999)。Studies of thermal polymerization of vegetable oils with a differential scanning calorimeter。  new window
 
 
 
 
第一頁 上一頁 下一頁 最後一頁 top
QR Code
QRCODE